Magnetic Separation Pilot Plant Project In the Philippines

Put customer requirements first and meet production standards

This project is a pilot plant of magnetic separation for our customers in the Philippines. The design criteria of the pilot plant are 3 tons per day and operate 8 hours per day. According to the customer’s requirements, the major equipment is as below:

1 x Jaw Crusher which can accommodate a 45mm feed size and can produce a 20mm product size.

Capacity: 1 Ton per hour

Size: 4’’x12’’ (gap opening)

Electric Motor: 5HP/220V/3 Phase

It must include below:

A. Electrical connections and local control switch

B. Elevated from the ground with metal stair/ramp

C. Vibrating screen:

Size: 20’’x48’’ (effective area of screening)

Nominal sieve opening of 10 mm (1.5 mesh)

Motor Drive: 1/4HP, 3 phase, 220V

1 x Conveyor System Facility

3-ply, 0.4 meters wide troughed belt conveyor (compatible for ore transport)

The length and inclination of the conveyor should be enough to effectively transport the ore from Jaw Crusher to the Vibrating Screen

Electric Motor Requirement: 3HP, 220V, 3 Phase

It must include all necessary support pedestal gear motor drive, all necessary electrical connections, safety steel catwalk, safety pull wire switch, and safety guards at every dangerous part of the conveyor normally accessible to the personnel.

1 x Roll Mill which can accommodate a feed size of 20mm and can produce a 10mm product size.

Roll Size: 12’’ diameterx14’’ length

Electric Motor: 3HP, 220V, 3 Phase

Capacity: 1 cubic meter

Thickness: 6mm

Material: Mild Steel Plate

It must include electrical connections and a local control switch, safety guards at every dangerous part of the conveyor normally accessible to the personnel, fine ore bin with conical bottom.

2x Rotating Ball Mills plus Steel Balls and Hydrocyclone Classifier which can accommodate 0.375 tons dry ore feed per hour or 0.13 cubic meter per hour.

Mill Size: 30’’(diameter)x72’’

Electric Motor Requirement: 3HP, 220V, 3 Phase

It must include appropriate cast iron or forged steel balls (with varying sizes), necessary electrical connections, water and slurry piping, appropriate conveyor belt feeder, 3-ply, 0.4-meter wide rubber belts, with variable frequency drive control panel, appropriate sump box, connections, centrifugal slurry pump, spare cyclone, safety guards at every dangerous part of conveyor and mill normally.

1 x Magnetic Separator which is a permanent magnetic drum type and a wide selection from the ultra high magnetic force.

Drum Diameter: 400mm

Drum Length: 600mm

Flow Capacity: 0.20 cubic meters per hour

Motor Requirement: 3HP, 220V, 3 Phase

It must have safety guards at every dangerous part of equipment normally accessible to the personnel, appropriate sump boxes for the magnetic materials and final concentrate, and all electrical connections.